Tile Cutter, TOPWAY 31 Inch 800mm Professional Manual Tile Cutter with Single Slide Rail and Laser Guide, Aluminiun Base, for Precision Cutting Porcelain Tiles 347713

Good value for money. I was sceptical for the price, but I found it Cuts tiles easily, even on an angle. Cut 1200 x 200 tiles neatly in half along it’s length to create skirtings. Will say that the Laser line is not very accurate, so didn’t use it. but if you pencil mark out the tiles front and back and spend a little time to line up the the cutting wheel, the cuts were perfect. Ideal for DIY

I, like most reviews tile alot, bought this based on price and needed a 1200mm . The other reviews are very accurate in that it only needs a light touch, if you use it like your rambo it will shatter tiles every time. But if you adopt a light touch and treat it like you would treat a fine lady it will cut cleanly, reliably and is easy to use. Laser is useless, about as much use as tits on a fish but other than that a great piece of kit for cheap price.

Needed a large tile cutter to cut 10mm 800 x 800 porcelain tiles. To be honest, was sceptical given the price and was fully expecting to have to grind every tile. It worked brilliantly. all cuts were perfect.Bear in mind that the scoring wheel is exactly that for scoring, so there is a bit of movement in the middle, but don't overwork it let the wheel do its thing and then gently use the breaking mechanism. I even managed a 15mm strip along the full length of the tile ( my Rubi 700 can struggle with that). Excellent value and don't be put off by negative reviews.

This cutter is next to useless.Dont waste your money. It isnt square bumps along when scoring tiles and after the first tile broke every other tile.

When choosing tile cutter i read lots of reviews, and some criticized cutters with two tubes running alongside as being not strong enough. So i chose this type with the bar in the middle. The cutter cuts really well indeed. I did 20m2 floor project with quite a few cuts and wasted no tiles (those were premium quality though) and all cuts are nice and clean. One aspect i did not consider is that it is not straightforward to position marker on the tile against the cut line because you cannot look at it straight down due to the bar being in the middle. So it is either looking at your marker from an angle (and learning how much it needs to be off the centre at that angle), or use tape measure and then ruler on the cutter. Both alternative methods are easy and stress free, just an extra unnecessary step in otherwise nice flow of work. Good luck!

I don't recommend it, very bad in many ways.

Cuts larger cuts great. Small diagonal cut not so good, had to cut the back of the tile halfway through then cut the top with the cutter.The laser is no accurate, OK as a guide but double check with the cutting wheel before cutting.You do not need a lot of pressure on the handle when cutting, gently does it and it will cut fine.

awesome , really well designed machine, complete with very useful laser guide. very happy